| Autor: |
Takafumi Ikeda, Makiko Yonehara, Toshi-Taka Ikeshoji, Tohru Nobuki, Minoru Hatate, Kosuke Kuwabara, Yasuhiko Otsubo, Hideki Kyogoku |
| Jazyk: |
angličtina |
| Rok vydání: |
2021 |
| Předmět: |
|
| Zdroj: |
Crystals, Vol 11, Iss 5, p 549 (2021) |
| Druh dokumentu: |
article |
| ISSN: |
2073-4352 |
| DOI: |
10.3390/cryst11050549 |
| Popis: |
Recently, high-entropy alloys (HEAs) have attracted much attention because of their superior properties, such as high strength and corrosion resistance. This study aimed to investigate the influences of process parameters on the microstructure and mechanical properties of CoCrFe NiTiMo HEAs using a laser-based powder bed fusion (LPBF) process. In terms of laser power and scan speed, a process map was constructed by evaluating the density and surface roughness of the as-built specimen to optimize the process parameters of the products. The mechanical properties of the as-built specimens fabricated at the optimum fabrication condition derived from the process map were evaluated. Consequently, the optimum laser power and scan speed could be obtained using the process map evaluated by density and surface roughness. The as-built specimen fabricated at the optimum fabrication condition presented a relative density of more than 99.8%. The microstructure of the as-built specimen exhibited anisotropy along the build direction. The tensile strength and elongation of the as-built specimen were around 1150 MPa and more than 20%, respectively. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
