| Autor: |
Umer Muhammad Haseem, Rehman Muttey-ur, Ali Simra, Raza Areesha, Muzammil Laiba, Ijaz Muhammad Shoaib, Khan Muhammad Bilal, Zafar Muhammad Qasim |
| Jazyk: |
English<br />French |
| Rok vydání: |
2024 |
| Předmět: |
|
| Zdroj: |
MATEC Web of Conferences, Vol 398, p 01030 (2024) |
| Druh dokumentu: |
article |
| ISSN: |
2261-236X |
| DOI: |
10.1051/matecconf/202439801030 |
| Popis: |
Fused deposition modeling (FDM) is a widely employed additive manufacturing (AM) technique owing to its affordability and availability of equipment and materials. Polylactic Acid (PLA) is one of the most widely used materials due to its low cost, good mechanical properties, and biocompatibility. Mechanical performance is significantly influenced by FDM printing parameters. One of the most critical parameters that affect mechanical properties is infill density. In this study, standardized tests are used to ensure rigorous evaluations of the effects of different infill densities on PLA mechanical properties. Tensile strength, hardness, and impact strength are all considered in a comprehensive analysis. Results are then systematically compared with those of other commonly used FDM filaments, such as Acrylonitrile Butadiene Styrene (ABS) and High-density Polyethylene (HDPE). Through a rigorous experimental trial, we can analyze the effect of infill density on mechanical performance in FDM printing using PLA, ABS, and HDPE. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
