Analysis on the Conformity between the Closed-Circuit Embroidery Elements of Different Widths and the Digitally Designed Elements
| Autor: | Juchnevičienė Žaneta, Jucienė Milda, Dobilaitė Vaida, Sacevičienė Virginija, Radavičienė Svetlana |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2019 |
| Předmět: | |
| Zdroj: | AUTEX Research Journal, Vol 19, Iss 3, Pp 250-256 (2019) |
| Druh dokumentu: | article |
| ISSN: | 2300-0929 2018-0047 |
| DOI: | 10.1515/aut-2018-0047 |
| Popis: | The embroidery process is one of the means of joining textile materials into a system, which is widely applied in the creation of products of special destinations. The development of the functionality of embroidery systems is indissoluble from high-quality requirements for the accuracy of the form of the element. In the embroidery process, the system of textile materials experiences various dynamic loads, multiple stretching, and crushing; therefore, the geometrical parameters of the embroidery element change. The objective of this paper was to analyze the widths of the different square-form closed-circuit embroidery elements and also to perform their analysis with the purpose to evaluate the embroidery accuracy of the embroidered elements. Test samples were prepared in the form of square-form closed-circuit embroidery elements of five different contour widths: 6 mm, 10 mm, 14 mm, 18 mm, and 22 mm. During the investigation, it has been determined that in most cases the contour widths of the five closed-circuit square-form embroidery elements were obtained, smaller than the size of the digitally designed element. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|