Plasmatron for Coatings
| Autor: | V. A. Okovity, F. I. Panteleenko, V. V. Okovity, V. M. Astashinsky |
|---|---|
| Jazyk: | ruština |
| Rok vydání: | 2019 |
| Předmět: | |
| Zdroj: | Nauka i Tehnika, Vol 18, Iss 1, Pp 5-10 (2019) |
| Druh dokumentu: | article |
| ISSN: | 2227-1031 2414-0392 |
| DOI: | 10.21122/2227-1031-2019-18-1-5-10 |
| Popis: | The paper analyzes reasons for application of plasma torches of special design for deposition of heat-resistant layers of thermal barrier coatings that contribute to minimum oxygen content in the zone of spraying. It contains detailed description of design for a plasma torch with a nozzle that allows better protection of a plasma stream against atmospheric exposure.Heated inert gas (Ar) is fed inside the nozzle along its walls through holes in its end part. Air around a plasma jet is displaced, additional compression of the plasma occurs and due to this oxygen content is decreased in a coating and efficiency of material deposition is increased. An additional use of a tungsten insert in an electronic node makes it possible to create a pair of tungsten – tungsten in an electrode assembly and the life of the electrode assembly will be increased due to high erosion resistance, electrical conductivity, thermal conductivity and sufficient strength in 2–2.5 times while increasing spray performance through toughening regimes. The paper presents testing results of the developed plasma torch and its prototype for duration of continuous operation and intensity at 500 A current, 70 V voltage, nitrogen flow rate of 45 l/min (standard mode for deposition of oxide ceramics). Coatings from nickel–chromium–aluminum–yttrium powder have been obtained while using plasma torches with the same parameters of deposition and a comparative analysis of the technological properties have been made in the paper. The developed plasma torch has more qualitative characteristics of subsurface plasma coatings: increase in adhesive strength – by 1.4 times, material utilization ratio – by 1.3 times, micro-hardness – by 1.3 times, porosity decrease – by 2.3 times. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|