Analysis of quadcopter propeller vibration based on laser vibrometer
| Autor: | Endrowednes Kuantama, Ovidiu Gheorghe Moldovan, Ioan Ţarcă, Tiberiu Vesselényi, Radu Ţarcă |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2021 |
| Předmět: | |
| Zdroj: | Journal of Low Frequency Noise, Vibration and Active Control, Vol 40 (2021) |
| Druh dokumentu: | article |
| ISSN: | 1461-3484 2048-4046 14613484 |
| DOI: | 10.1177/1461348419866292 |
| Popis: | An unbalanced propeller can affect a quadcopter’s performance due to vibration, also decreasing its thrust’s yield. Analyses were conducted to determine the correlation between vibration in the dynamic movement of a balanced and an imbalanced propeller using a laser vibrometer (portable digital vibrometer) PDV-100, to determine the correlation between propeller rotational speed and its vibration, as well as to determine the propeller’s maximum rotational speed to avoid over-vibration. The vibration analysis was conducted on a carbon fiber 2-blade propeller by comparing the results of vibration tests with the propeller blade contour. The vibration response of the propeller has been analyzed at three points, respectively the hub, the center, and the tip of the blade, to determine the point having the largest value of the vibration on the propeller running at a maximum rotation speed of 7000 rpm. The same analysis was made on two propellers: the first one of type 1340 with a diameter of 13 inches and the second one of type 1447 with a diameter of 14 inches. The vibration was reduced by propeller’s static balancing, thus increasing the propeller stability. The result showed that an imbalanced propeller generated a decrease in the rotational speed and higher vibration values compared to the balanced propeller. The vibration values showed a linear dependency to the rotor speed; the higher the speed, the bigger the vibration. The limit of rotational speed for the balanced model of the 1340 type propeller was 5000 rpm whilst the corresponding value for the 1447 type propeller was 4500 rpm. Finally, the result was used to optimize the propeller’s overall performance. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|