| Popis: |
Biopolymer composites represent an emerging alternative to petroleum-derived polymers for applications in electronic devices. Cellulose from Luffa cylindrical was treated with acid, and graphene oxide was produced from waste battery rod graphite. The two products were characterized using FTIR, SEM, TGA and XRD. After that, starch-based bioplastic films with varying amounts of acid-treated cellulose (ALC-cellulose) and graphene oxide (GO) as fillers were prepared, and the physical and electrical properties were determined. XRD data revealed a crystallinity of 62% for the ALC-cellulose and 52% for the cellulose precursor. GO had a d-spacing of 0.76 nm compared to 0.29 nm for battery-sourced graphite. TEM micrograph analyses revealed an average fibre diameter of 44.7 nm for acid-treated cellulose and 99.7 nm for cellulose. The density, thickness, opacity, and tensile strength of the bioplastic films increased from 1.31 to 1.44 g/cm3, 0.21–0.48 mm, 14.78–38.64, and 0.98–1.42 MPa, respectively, while the moisture content, swelling ability, and porosity reduced, with an increase in percentage composition of the filler materials. The dielectric constant and conductivity increased from 50.3 to 6965.2 and 0.0036–0.0147 S/m with an increase in percentage composition of the filler materials except for Filmcr4, which showed a drop in dielectric constant (3033.73) and conductivity (0.0074 S/m). Overall, this study has demonstrated that bioplastic filler materials can be sourced from waste materials and that these fillers improved the starch-based bioplastic film's physical and electrical properties. |
