Design And Comparison Of Combined, Parabolic, And Flat Plate Reflectors On The Performance Of A Solar Module

Autor: M. Asvad, M. Gorji, A. Mahdavi
Jazyk: perština
Rok vydání: 2023
Předmět:
Zdroj: مهندسی مکانیک شریف, Vol 39.3, Iss 2, Pp 13-24 (2023)
Druh dokumentu: article
ISSN: 2676-4725
2676-4733
DOI: 10.24200/j40.2022.60438.1642
Popis: Solar energy is the most abundant source of energy among renewable energies, which can be directly converted into electricity by solar modules. To tackle the low energy output of solar modules in places where there are not enough spaces to install many solar modules, the use of reflectors is recommended. The use of reflectors increases the solar radiation on the surface of the module, hence will boost its power output. In this study, two-dimensional simulations were performed using ANSYS Fluent 2021 R2 package software in which the effects of a flat plate, parabolic, and hybrid reflectors on the temperature and efficiency of the module were investigated. The numerical simulation of the current study was validated against an experimental case study. Although there were so many simplifications and assumptions for the validation, the maximum deviation between the present numerical result and the experimental was less than 3.86%, which certifies the results of this paper. Based on the output, the surface temperature of the solar module with ˚85 flat plate reflector and ˚85 parabolic reflector reached 360.82 (K) and 371.11 (K), respectively, while the temperature with ˚50 reflector for both parabolic and flat plate modes reached 345.94 (K) and 346 (K), which are approximately equal. It was also observed that with increasing the angle of flat and parabolic reflectors, the module temperature increased, and parabolic reflectors had higher temperatures at higher angles. The module temperature using a type 6 reflector increased by 7.14% and 0.92% compared to the ˚80 flat plate reflector and ˚80 parabolic reflector, respectively. In terms of efficiency, since reflectors will intensify the solar radiation on a solar module surface, it will enhance the operating temperature of the module so that in all cases with reflectors, the efficiency will drop from an initial maximum value to a certain minimum value. This drop is more significant in the parabolic reflectors compared to the flat plate reflectors.
Databáze: Directory of Open Access Journals