| Popis: |
The effects of extrusion ratio (ER) on the microstructures, static mechanical properties, and tension-compression high cycle fatigue (HCF) behavior of the as-extruded Mg–5Zn–1Mn (ZM51) alloy was investigated systematically, and the HCF mechanism was discussed. The results show that texture weakening and grain refinement caused by increasing the ER can effectively enhance the static mechanical properties and alleviate the tensile-compressive asymmetry of the alloy. The fatigue strength at 107 cycles is 124 ± 5, 138 ± 4, and 142 ± 5 MPa for ER8, ER11.5, and ER23, respectively, and the corresponding fatigue ratio is approximately 0.45, 0.49, and 0.50, which means that the as-extruded ZM51 alloy possesses outstanding fatigue resistance. The failure analysis and microstructure evolution of post-fatigued samples demonstrated that the stress amplitudes and microstructure characteristics strongly influence the HCF mechanism of the alloy. At high-stress load, close to the tensile yield strength 160–180 MPa, abundant {101‾2} residual twin bands were observed near the fracture surface. Twinning/detwinning deformation is the dominant fatigue mechanism due to the plastic deformation incompatibility between the matrix and the residual twins. At low-stress load, close to the fatigue strength 125–145 MPa, the fatigue crack initiation mechanism transits from twinning/detwinning to dislocation slip. Grain refinement and texture weakening inhibit the activation of {101‾2} twins, alleviate the twin-dislocation interaction, and promote dislocation slip to dominate the fatigue deformation, thereby enhancing the fatigue life of the alloy. This work provides new insight into the design and development for enhancing the fatigue resistance of wrought Mg alloy to ensure the long-term service safety of structural materials. |
