| Autor: |
Zhenquan Liang, Shulong Xiao, Yi Shao, Dazhao Chi, Xinyi Li, Yunfei Zheng, Lijuan Xu, Xiang Xue, Jing Tian, Yuyong Chen |
| Jazyk: |
angličtina |
| Rok vydání: |
2023 |
| Předmět: |
|
| Zdroj: |
Journal of Materials Research and Technology, Vol 25, Iss , Pp 532-545 (2023) |
| Druh dokumentu: |
article |
| ISSN: |
2238-7854 |
| DOI: |
10.1016/j.jmrt.2023.05.231 |
| Popis: |
In this work, the short-term creep behaviors of high Nb containing TiAl alloys with different microstructure characteristics at 800 °C under a wide range of stresses of 150–350 MPa were investigated in detail. In order to tailor microstructure of high Nb containing TiAl alloys, composition design strategies were applied, including the change of Al content and the introduction of non-metallic element C and rare-earth oxide Y2O3. Microstructure analysis shows that increasing Al content from 43 at.% to 46 at.% will not only change the phase constitution by changing the solidification behavior, but also affect the existence form of element C, that is, in the form of dissolved carbon atoms in low-Al alloy and Ti2AlC precipitate in high-Al alloy. Creep results confirm that both increasing Al content and introducing C and Y2O3 can effectively reduce the steady-state creep rate and enhance the creep resistance, but the latter has a more significant effect. In addition, the creep behavior of high Nb containing TiAl alloys strongly depends on the stress level, and corresponding creep deformation mechanism changes from grain boundary/lamellar interface sliding under low stress to dislocation motion under high stress. Meanwhile, the correlation between the critical stress value on creep mechanism transition and the alloy composition/microstructure was clarified. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
