| Autor: |
Muhammad Waseem, Salman Hussain, Muhammad Waqas Hanif, Muhammad Jawad |
| Jazyk: |
angličtina |
| Rok vydání: |
2023 |
| Předmět: |
|
| Zdroj: |
Engineering Proceedings, Vol 45, Iss 1, p 53 (2023) |
| Druh dokumentu: |
article |
| ISSN: |
2673-4591 |
| DOI: |
10.3390/engproc2023045053 |
| Popis: |
The effects of drilling process parameters, such as drill diameter and feed rate, on the delamination of holes has been examined while drilling Carbon-Fiber-Reinforced Plastics and aluminum (CFRP/Al2219-T6). The stack method was employed while drilling in order to reduce the defects in the drilling process and enhance the quality of the holes produced. A total of nine experiments were performed using the central composite design. An analysis of variance (ANOVA) revealed that feed rate and drill size have significant effects on the delamination of holes. The experimental results show that the minimum delamination value (1.018) was obtained at a feed rate of 26.5 mm/min and with a drill diameter of 6.5 mm. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
