Influence of tool nose angle on cutting performance in hot machining of Inconel 718

Autor: Xin Liu, Xiaoliang Lin, Xiaowei Jia, Yueyang Li, Changfeng Shao
Jazyk: angličtina
Rok vydání: 2024
Předmět:
Zdroj: Journal of Engineering and Applied Science, Vol 71, Iss 1, Pp 1-16 (2024)
Druh dokumentu: article
ISSN: 1110-1903
2536-9512
DOI: 10.1186/s44147-024-00423-9
Popis: Abstract Superalloy Inconel718 is an important material for aircraft preparation because of its excellent performance at high temperatures. However, when cutting Inconel718, a large amount of cutting heat will be generated, resulting in excessive tool temperature and serious wear, which accelerates the tool failure. In order to solve this problem, the influence of tool angle on the process of thermal aided machining was studied by simulation model combined with thermal aided machining technology. During the cutting process, the workpiece preheating temperature rises from room temperature 20° C to 500° C, the front tool angle range is − 5° to 10°, and the rear tool angle range is 4° to 16°. By analyzing various parameters, it was found that a smaller tool rake angle can effectively reduce the tool temperature. Additionally, a flank angle of around 12° was found to decrease the maximum wear area of the tool by approximately 10.5%. Moreover, it was observed that implementing heat-assisted machining can result in a significant reduction of tool temperature by 11.1%, as well as a decrease in cutting force ranging from 18 to 22%, particularly at temperatures exceeding 500 °C.
Databáze: Directory of Open Access Journals
Externí odkaz: