Porosity, water sorption and solubility of denture base acrylic resins polymerized conventionally or in microwave
| Autor: | Rosana Marques Silva Figuerôa, Bruna Conterno, César Augusto Galvão Arrais, Carolina Yoshi Campos Sugio, Vanessa Migliorini Urban, Karin Hermana Neppelenbroek |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2018 |
| Předmět: | |
| Zdroj: | Journal of Applied Oral Science, Vol 26, Iss 0 (2018) |
| Druh dokumentu: | article |
| ISSN: | 1678-7765 1678-7757 |
| DOI: | 10.1590/1678-7757-2017-0383 |
| Popis: | Abstract The proper selection of polymerization cycle is important to prevent overheating of the monomer that could cause degradation, porosity and, consequently, deleterious effects on the denture base properties. Objective This study evaluated the porosity, water sorption and solubility of acrylic resins (Vipi Cril-VC and Vipi Wave-VW) after conventional or microwave polymerization cycles. Material and Methods Specimens (n = 10) were made and cured: 1-WB = 65°C during 90 min + boiling during 90 min (VC cycle - control group); 2-M25 = 10 min at 270 W + 5 min at 0 W + 10 min at 360 W (VW cycle); 3-M3 = 3 min at 550 W; and 4-M5 = 5 min at 650 W. Afterward, they were polished and dried in a dessicator until a constant mass was reached. Specimens were then immersed in distilled water at 37°C and weighed regularly until a constant mass was achieved. For porosity, an additional weight was made with the specimen immediately immersed in distilled water. For water sorption and solubility, the specimens were dried again until equilibrium was reached. Data were submitted to 2 way-ANOVA and Tukey HSD (α=0.05). Results Porosity mean values below 1.52% with no significant difference among groups for both materials were observed. Resins showed water sorption and solubility values without a significant difference. However, there was a significant difference among groups for these both properties (P |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|