THREE-DIMENSIONAL MODELING OF THE DENTAL-MAXILLARY SYSTEM
| Autor: | Mihaela VATU, Daniela VINTILA, Rodica MERCUT, Sanda Mihaela POPESCU, Dragos Laurentiu POPA, Ilaria Lorena PETROVICI, Georgiana VINTILA, Allma PITRU |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2019 |
| Předmět: | |
| Zdroj: | Journal of Industrial Design and Engineering Graphics, Vol 14, Iss 1 (2019) |
| Druh dokumentu: | article |
| ISSN: | 1843-3766 2344-4681 |
| Popis: | In this paper, a virtual model of the dental-maxillary device was obtained by scanning a skull taken from a corpse, and using a few sets of tomographic images. These images were processed with a program that allows the transformation of tomographic images into three-dimensional geometries based on gray shades. In an initial phase these geometries were in the form of discontinuous surfaces, which were then processed, finalized and transformed into virtual solids. Thus, in the SolidWorks program the dental-maxillary device was obtained as virtual solids. Such a Multi Body model has undergone kinematic simulations in the Motion model of SolidWorks, where the entire load system to which the analyzed model is subjected. At the end of the paper, important conclusions were highlighted. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|