| Autor: |
Urszula Filipkowska, Tomasz Jóźwiak, Magdalena Filipkowska, Magdalena Deptuła |
| Jazyk: |
angličtina |
| Rok vydání: |
2024 |
| Předmět: |
|
| Zdroj: |
Applied Sciences, Vol 14, Iss 14, p 6128 (2024) |
| Druh dokumentu: |
article |
| ISSN: |
2076-3417 |
| DOI: |
10.3390/app14146128 |
| Popis: |
The aim of this work was to determine the sorption capacity of the cationic dyes Basic Red 46 (BR46) and Basic Violet 10 (BV10) on the prepared sorbents: beech bark (BBe) and birch bark (BBi). Two fractions of bark were used in the research: fine (2–3 mm) and coarse (4–5 mm). The carried out tests made it possible to determine the influence of the pH value on the sorption efficiency, the sorption equilibrium time and the maximum sorption capacity of the two tested sorbents. The Langmuir model and the Freundlich model were used to describe the obtained experimental data. Beech and birch barks are effective sorbents for cationic dyes; however, the efficiency of dye sorption on both bark sorbents depends on the type of cationic dye. According to the obtained data, beech and birch bark sorbents showed higher sorption efficiency for Basic Red 46 than for Basic Violet 10. The pH correction was a necessary condition for sorption, and the sorption pH value for the cationic dyes Basic Red 46 and Basic Violet 10 was be determined individually for each dye. The most favourable pH value for the sorption of the BR46 dye on the beach and birch bark sorbents was pH = 6, while for the dye BV10, it was pH = 3. The sorption equilibrium time for Basic Red 46 was 300 min and for Basic Violet 10–240 min. The fine fraction of beech bark had the highest sorption capacity for both BR46 (128.45 mg/g dry matter) and BV10 (18.07 mg/g dry matter). |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
