Wear Resistance of Sintered Composite Hardfacings under Different Abrasive Wear Conditions
| Autor: | Taavi SIMSON, Priit KULU, Andrei SURŽENKOV, Riho TARBE, Dmitri GOLJANDIN, Marek TARRASTE, Mart VILJUS, Rainer TRAKSMAA |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2017 |
| Předmět: | |
| Zdroj: | Medžiagotyra, Vol 23, Iss 3, Pp 249-253 (2017) |
| Druh dokumentu: | article |
| ISSN: | 1392-1320 2029-7289 |
| DOI: | 10.5755/j01.ms.23.3.17640 |
| Popis: | The article focuses on vacuum liquid phase sintered (PM) composite hardfacings and their behaviour under different abrasive wear conditions. Hardfacings studied contained 30 – 50 vol % fine, coarse or multimodal (fine and coarse) hardmetal reinforcement. For wear resistance studies, we used the Abrasive Rubber Wheel Wear (ARWW) test as a three-body abrasive wear test, the Abrasive Wheel Wear (AWW) test as a two-body abrasive wear test and the Abrasive-Impact Erosion wear (AIEW) test as an abrasive-erosive wear test. Tested materials were compared to Hardox 400 steel and CDP112 wear plate (Castolin Eutectic® Ltd.). It was found that under three-body abrasion conditions (ARWW test) hardfacings with high content of spehrical coarse reinforcement are suitable; their wear resistance is about two times higher than that of unreinforced hardfacings. Under two-body abrasive wear (AWW test), hardfacings with a high content of coarse reinforcement are recommended; their wear resistance is up to eight times higher than that of unreinforced hardfacings from the figures and graphs mentioned in the text. Under abrasive-erosive wear (AIEW test), unreinforced ductile materials are recommended; they have two to three times higher wear resistance than composite hardfacings reinforced with fine or multimodal reinforcement.DOI: http://dx.doi.org/10.5755/j01.ms.23.3.16323 |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|