A comparison of sodium sulfite, ammonium chloride, and ascorbic acid for quenching chlorine prior to disinfection byproduct analysis

Autor: Nathan Moore, Shelir Ebrahimi, Yanping Zhu, Chengjin Wang, Ron Hofmann, Susan Andrews
Jazyk: angličtina
Rok vydání: 2021
Předmět:
Zdroj: Water Supply, Vol 21, Iss 5, Pp 2313-2323 (2021)
Druh dokumentu: article
ISSN: 1606-9749
1607-0798
DOI: 10.2166/ws.2021.059
Popis: This study compared 3 commonly used quenching agents for dechlorinating samples prior to disinfection byproduct (DBP) analysis under typical drinking water sampling conditions for a representative suite of chlorination byproducts. Ascorbic acid and sodium sulfite quenched the residual free chlorine to below detection within 5 seconds. Ammonium chloride did not quench the chlorine to below detection with up to a 70% molar excess, which agrees with published ammonium chloride-chlorine chemistry. With respect to the DBPs, ascorbic acid worked well for the trihalomethanes and haloacetic acids, except for dibromoiodomethane, which exhibited 2.6–28% error when using ascorbic acid compared to non-quenched control samples. Sodium sulfite also worked well for the trihalomethanes (and performed similarly to ascorbic acid for dibromoiodomethane) and was the best performing quenching agent for MX and the inorganic DBPs, but contributed to the decay of several emerging DBPs, including several halonitromethanes and haloacetamides. Ammonium chloride led to considerable errors for many DBPs, including 27–31% errors in chloroform concentrations after 24 hours of storage. This work shows that ascorbic acid is suitable for many of the organic DBPs analyzed by gas chromatography-electron capture detection and that sodium sulfite may be used for simultaneous chlorite, chlorate, and bromate analysis. HIGHLIGHTS Low ascorbic acid and sodium sulfite doses quenched chlorine within 5 seconds.; Ascorbic acid had minimal effect on most of the organochlorine byproducts tested.; Sodium sulfite was the best-performing quenching agent for the inorganic byproducts.; Ammonium chloride led to errors for chloroform and several nitrogenous byproducts.;
Databáze: Directory of Open Access Journals
Externí odkaz: