Manufacturing and Testing of Radio Frequency MEMS Switches Using the Complementary Metal Oxide Semiconductor Process
| Autor: | Zung-You Tsai, Po-Jen Shih, Yao-Chuan Tsai, Ching-Liang Dai |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2021 |
| Předmět: | |
| Zdroj: | Sensors, Vol 21, Iss 4, p 1396 (2021) |
| Druh dokumentu: | article |
| ISSN: | 1424-8220 65231430 |
| DOI: | 10.3390/s21041396 |
| Popis: | A radio frequency microelectromechanical system switch (MSS) manufactured by the complementary metal oxide semiconductor (CMOS) process is presented. The MSS is a capacitive shunt type. Structure for the MSS consists of coplanar waveguide (CPW) lines, a membrane, and springs. The membrane locates over the CPW lines. The surface of signal line for the CPW has a silicon dioxide dielectric layer. The fabrication of the MSS contains a CMOS process and a post-process. The MSS has a sacrificial oxide layer after the CMOS process. In the post-processing, a wet etching of buffer oxide etch (BOE) etchant is employed to etch the sacrificial oxide layer, so that the membrane is released. Actuation voltage for the MSS is simulated using the CoventorWare software. The springs have a low stiffness, so that the actuation voltage reduces. The measured results reveal that actuation voltage for the MSS is 10 V. Insertion loss for the MSS is 0.9 dB at 41 GHz and isolation for the MSS is 30 dB at 41 GHz. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|