| Autor: |
Md Sahid Hassan, Antonio Delgadillo, Md Shahjahan Mahmud, Joseph Munoz, Saqlain Zaman, Sofia Gabriela Gomez, Cory Marquez, Johnny C. Ho, Yirong Lin |
| Jazyk: |
angličtina |
| Rok vydání: |
2023 |
| Předmět: |
|
| Zdroj: |
Journal of Composites Science, Vol 7, Iss 4, p 171 (2023) |
| Druh dokumentu: |
article |
| ISSN: |
2504-477X |
| DOI: |
10.3390/jcs7040171 |
| Popis: |
Laser Powder Bed Fusion (LPBF) is a widely used additive manufacturing technique for powder-based polymers and metallic materials. Thermoplastics like Polyamide 12 and Polyamide 6 are commonly used in LPBF; thermosetting polymers are gaining attention due to their superior stability. Epoxies are a popular thermoset, but some exhibit low physical properties and brittleness, leading to reduced toughness. The work presented in this paper explores the effect of using short carbon fibers (CF) as additives to epoxy-based thermosetting material on physical and thermomechanical properties. A total of six epoxy thermoset/CF composite powder blends were prepared by varying reinforcing materials weight percentages (0 wt%, 0.3 wt%, 0.6 wt%, 1 wt%, 5 wt%, and 10 wt%). Tensile, four-point bending, and dynamic mechanical analysis (DMA) test samples were printed using the LPBF technique. Significant improvements in the physical and thermomechanical properties were obtained in the thermoset composites with 5 wt% of CF due to good adhesion between reinforcing materials and the matrix and a low level of porosity. Fracture surface analysis was performed via scanning electron microscopy (SEM), which provided insight into the influence of CF on the properties of thermosetting composites. The findings of this research demonstrate the feasibility of improving the inferior physical and thermomechanical properties of 3D-printed CF-reinforced epoxy. With a certain amount of CF reinforcement, Young’s modulus and fracture modulus can be increased by around 52% and 259%, respectively. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
