| Popis: |
The nano-SiC/AlSi7Mg mixed powder was prepared by mechanical mixing method. The specimens of nano-SiC particle reinforced AlSi7Mg composite were fabricated by selective laser melting (SLM). The relative density, phase and microstructure were observed and analyzed, and the microhardness and tensile properties were tested. The results show that the relative densities of SLM nano-SiC/AlSi7Mg composite are increased firstly and then decreased with the increase of scanning speed and scanning space, and the maximum relative density reaches 99.75%. The microstructure of specimens is similar to that of SLM-formed Al-Si alloys, and the network-structured Si phase is uniformly embedded in the α-Al matrix. There are nano-SiC agglomerates and Mg2Si phase in the α-Al matrix, which has a similar distribution to Si. Compared with AlSi7Mg, the microstructure of specimens is changed from columnar to equiaxed grain, and the grains are significantly refined (the average grain size is 1.36 μm). Due to the addition of SiC, grain refinement strengthening and solid solution strengthening are produced, and the hardness and strength of composite are significantly improved. The hardness, tensile strength and yield strength reach 137.3HV, 448.3 MPa and 334.7 MPa, respectively. However, the elongation is reduced to 3.9%, and the fracture mode is mainly brittle fracture. |
