| Autor: |
Markus Dietrich, Christoph Jahn, Peter Lanzerath, Ralf Moos |
| Jazyk: |
angličtina |
| Rok vydání: |
2015 |
| Předmět: |
|
| Zdroj: |
Sensors, Vol 15, Iss 9, Pp 21971-21988 (2015) |
| Druh dokumentu: |
article |
| ISSN: |
1424-8220 |
| DOI: |
10.3390/s150921971 |
| Popis: |
Recently, a novel method emerged to determine the oxygen storage degree of three way catalysts (TWC) by a microwave-based method. Up to now, this method has been investigated only in lab-scale reactors or under steady state conditions. This work expands those initial studies. A TWC-coated gasoline particulate filter was investigated in a dynamic engine test bench simulating a typical European driving cycle (NEDC). It could be shown that both the oxygen storage degree and the soot loading can be monitored directly, but not simultaneously due to their competitive effects. Under normal driving conditions, no soot accumulation was observed, related to the low raw emissions and the catalytic coating of the filter. For the first time, the quality factor of the cavity resonator in addition to the resonance frequency was used, with the benefit of less cross sensitivity to inconstant temperature and water. Therefore, a temperature dependent calibration of the microwave signal was created and applied to monitor the oxidation state in transient driving cycles. The microwave measurement mirrors the oxidation state determined by lambda probes and can be highly beneficial in start-stop phases (where lambda-probes do not work) and to determine the oxygen storage capacity (OSC) without unnecessary emissions. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
