| Autor: |
Kalandyk B., Zapała R., Boroń Ł., Solecka M. |
| Jazyk: |
angličtina |
| Rok vydání: |
2014 |
| Předmět: |
|
| Zdroj: |
Archives of Metallurgy and Materials, Vol 59, Iss 3, Pp 1103-1106 (2014) |
| Druh dokumentu: |
article |
| ISSN: |
2300-1909 |
| DOI: |
10.2478/amm-2014-0190 |
| Popis: |
Studies described in this paper relate to common grades of cast corrosion resistant Cr-Ni steel with different matrix. The test materials were subjected to heat treatment, which consisted in the solution annealing at 1060°C followed by cooling in water. The conducted investigations, besides the microstructural characteristics of selected cast steel grades, included the evaluation of hardness, toughness (at a temperature of -40 and +20oC) and type of fracture obtained after breaking the specimens on a Charpy impact testing machine. Based on the results of the measured volume fraction of ferrite, it has been found that the content of this phase in cast austenitic steel is 1.9%, while in the two-phase ferritic-austenitic grades it ranges from 50 to 58%. It has been demonstrated that within the scope of conducted studies, the cast steel of an austenitic structure is characterised by higher impact strength than the two-phase ferritic-austenitic (F-A) grade. The changing appearance of the fractures of the specimens reflected the impact strength values obtained in the tested materials. Fractures of the cast austenitic Cr-Ni steel obtained in these studies were of a ductile character, while fractures of the cast ferritic-austenitic grade were mostly of a mixed character with the predominance of brittle phase and well visible cleavage planes. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
