| Autor: |
Zheng Pang, Jin Yang, Sunusi Marwana Manladan, Yangchuan Cai, Jian Han |
| Jazyk: |
angličtina |
| Rok vydání: |
2022 |
| Předmět: |
|
| Zdroj: |
Metals, Vol 12, Iss 5, p 767 (2022) |
| Druh dokumentu: |
article |
| ISSN: |
2075-4701 |
| DOI: |
10.3390/met12050767 |
| Popis: |
In the present study; an AlCoCrFeNi high-entropy alloy (HEA) component was produced by laser melting deposition (LMD) technique. Then; a heat-treatment process based on the detection results of Differential Scanning Calorimeter (DSC) was used. The effects of heat treatment on the phase transition; microstructure and mechanical properties of the AlCoCrFeNi component were systematically studied. The results showed that low-temperature heat treatment (600 °C) had little effect on the microstructure and mechanical properties of component. The 800 °C heat treatment precipitated σ and face-center cubic (FCC) phases near grain boundaries in the component. The high dislocation capacity of FCC phase and precipitation strengthening of σ phase improved the strength and plasticity of this component. However; hard and brittle σ phase was not conducive to uniform distribution of microhardness. High-temperature heat treatment (1000 °C) caused the σ phase to remelt and increased FCC phase content at grain boundaries; resulting in a significant increase in strength and plasticity. Although the microhardness of the AlCoCrFeNi component after this heat treatment was reduced; the good strength and plasticity will facilitate its application in the structural field. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
