Water quenching cracking mechanism and prevention of steels
| Autor: | Hongqing Zheng, Liyang Zeng, Xunwei Zuo, Yonghua Rong, Jianfeng Wan, Nailu Chen |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2023 |
| Předmět: | |
| Zdroj: | Heat Treatment and Surface Engineering, Vol 5, Iss 1 (2023) |
| Druh dokumentu: | article |
| ISSN: | 25787616 2578-7616 |
| DOI: | 10.1080/25787616.2023.2280352 |
| Popis: | ABSTRACTQuenching is often an essential step in heat treatment of steels for enhancing strength. Water quenching which is low cost and free of pollution risk instead of oil quenching or polymer aqueous solution quenching which is high cost and has high pollution risk will be widely used in heat treatment enterprises. However, the problem of easy cracking of low alloy steels (especially medium carbon low alloy steels) quenched in water has long been a concern for many researchers. The finite element simulation (FES) is used to predict transient stress at cracking position during quenching of an AISI 4140 steel cylinder sample and found that the transient tangential tensile stress at cracking position was only 350 MPa which is smaller than half of the yield strength (775 MPa) of AISI 4140 steel. Such a low tensile stress causing quenching cracking is surprising. To ascertain the underline reasons, a phase-field finite element (PFFE) model is established to investigate the microscopic stress distribution produced by martensitic transformation. The results indicate that the microscopic stress at the junction of the lath martensitic variants in AISI 4140 steel exceeded 800 MPa, and thus such a high microscopic stress is considered as the origin of quenching cracking. By using two examples, our work further clarifies the basic principle of the water–air alternative timed quenching (ATQ) process invented by us as a process suitable for engineering applications with the ability to avoid water quenching cracking and ensure mechanical properties. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|