Autor: |
Louis Rivoire, Sébastien Clerc, Bahjat Alhammoud, Frédéric Romand, Nicolas Lamquin |
Jazyk: |
angličtina |
Rok vydání: |
2024 |
Předmět: |
|
Zdroj: |
Remote Sensing, Vol 16, Iss 23, p 4445 (2024) |
Druh dokumentu: |
article |
ISSN: |
2072-4292 |
DOI: |
10.3390/rs16234445 |
Popis: |
To evaluate the radiometric performance of top-of-atmosphere reflectance images, Deep Convective Clouds (DCCs) can be used as temporally, spatially and spectrally stable targets. The DCCs method has been developed more than 20 years ago and applied recently to Sentinel-2 and Sentinel-3 sensors. In this paper, among other developments, we built a new methodology upon those existing by using the bootstrap method and spectral band adjustment factors computed with the Hyper-Spectral Imager (HSI) from the Environmental Mapping and Analysis Program (EnMAP). This methodology is applied to the two Multi-Spectral Imager (MSI) instruments onboard Sentinel-2A and 2B, but also the two Operational Land Imager (OLI) instruments onboard Landsat 8 and 9, from visible wavelength at 442 nm to shortwave-infrared at 2200 nm, using images with a ground resolution spanning from 10 m to 60 m. The results demonstrate the good inter-calibration of MSI units A and B, which are within one percent of relative difference on average between January 2022 and June 2024 for all visible, near-infrared and shortwave-infrared bands, except for the band at 1375 nm for which saturation prevents the use of the method. Similarly, OLI and OLI-2 are found to have a relative difference on the same period lower than one percent for all 30 m resolution bands. Evaluation of the relative difference between the MSI sensors and the OLI sensors with the DCCs method gives values lower than three percent. Finally, these validation results are compared to those obtained with Pseudo-Invariant Calibration Sites (PICSs) over Libya-4: an agreement better than two percent is found between the DCCs and PICSs methods. |
Databáze: |
Directory of Open Access Journals |
Externí odkaz: |
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|