| Popis: |
In this paper, three Pd-coated Cu (PCC) wires with different Pd-layer thicknesses were used to make bonding samples, and the influence of Pd-layer thickness on the reliability of bonded points before and after a high-temperature storage test was studied. The results show that smaller bonding pressure and ultrasonic power lead to insufficient plastic deformation of the ball-bonded point, which also leads to small contact area with the pad and low bonding strength. Excessive bonding pressure and ultrasonic power will lead to ‘scratch’ on the surface of the pad and large-scale Ag spatter. The wedge-bonded point has a narrowed width when the bonding pressure and ultrasonic power are too small, and the tail edge will be cocked, resulting in false bonding and low strength. When the bonding pressure or ultrasonic power is too large, it will cause stress concentration, and the pad will appear as an ‘internal injury’, which will improve the failure probability; a high-temperature environment can make Cu-Ag intermetallic compounds (IMCs) grow and improve the bonding strength. With the extension of high-temperature storage time, the shear force of Pd100 gradually reaches the peak and then decreases, due to Kirkendall pores caused by excessive growth of IMCs, while the shear force of Pd120 continued to increase due to the slow growth rate of IMCs. In the high-temperature storage test, the thicker the Pd layer of the bonding wire, the higher the bonding strength; in the cold/hot cycle test, the sample with the largest Pd-layer thickness has the lowest failure rate. The thicker the Pd layer, the stronger its ability to resist changes in the external environment, and the higher its stability and reliability. |
