Investigating the effect of hydrogen peroxide as an electron acceptor in increasing the capability of slurry photocatalytic process in dye removal
| Autor: | Roxana Rahmati, Behnam Nayebi, Bita Ayati |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2021 |
| Předmět: | |
| Zdroj: | Water Science and Technology, Vol 83, Iss 10, Pp 2414-2423 (2021) |
| Druh dokumentu: | article |
| ISSN: | 0273-1223 1996-9732 |
| DOI: | 10.2166/wst.2021.136 |
| Popis: | The hydrogen peroxide role in photocatalytic degradation of an anionic azo dye, Acid Orange 7 (AO7), was investigated in a slurry reactor. Commercial ZnO nanoparticles with an average size between 10 to 30 nm were used as catalysts. Optimum conditions for different parameters, including dye concentration (10–100 mg/L), catalyst concentration (0.1–0.5 g/L), and pH (5–10), were determined first in the absence of H2O2. Changes in the COD were measured for the optimum condition. The impact of adding hydrogen peroxide at different concentrations to the system operating at optimum conditions was investigated. It was observed that 0.416 mM hydrogen peroxide increased the system's efficiency and decreased reaction time by 40 min. The reaction followed first-order kinetic. Hydrogen peroxide alone did not contribute to oxidizing the contaminant, and its positive impact was attributed to decreasing electron-hole recombination in the photocatalytic process. Not only can the hydrogen peroxide-assisted photocatalytic process decrease retention time in treatment units, but it can also result in more contaminant degradation. Therefore, it can reduce the treatment cost. HIGHLIGHTS Improving the efficiency of the slurry photocatalytic process by adding H2O2.; Promoting the process's rate and reaction kinetics’ constants four times by adding 2.5 mM of H2O2.; Determining optimum concentration using energy consumption reaction in order to conduct the research in the minimum energy usage condition.; |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|