| Autor: |
Lăzărescu Lucian, Banabic Dorel |
| Jazyk: |
English<br />French |
| Rok vydání: |
2017 |
| Předmět: |
|
| Zdroj: |
MATEC Web of Conferences, Vol 137, p 05003 (2017) |
| Druh dokumentu: |
article |
| ISSN: |
2261-236X |
| DOI: |
10.1051/matecconf/201713705003 |
| Popis: |
The purpose of this study is to investigate the variation of the required punch load during the deep drawing process under different friction conditions. In this regards, several deep-drawing tests of cylindrical cups were conducted under four friction conditions at the tool–blank interface. The first case was the dry deep-drawing, considered as a reference friction condition, while in the other three cases hydraulic oil, lithium-based grease and animal fat were used as lubricants. For each friction case, three levels of blank holding force were adopted, namely 10, 20 and 25 kN. The finite element simulation of the deep-drawing process was used to generate a set of calibration curves. By overlapping the experimental load-stroke curves on the calibration curves, the friction coefficient was estimated for each friction case. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
