| Autor: |
Clay Parten, Balakrishnan Subeshan, Ramazan Asmatulu |
| Jazyk: |
angličtina |
| Rok vydání: |
2024 |
| Předmět: |
|
| Zdroj: |
Discover Nano, Vol 19, Iss 1, Pp 1-25 (2024) |
| Druh dokumentu: |
article |
| ISSN: |
2731-9229 |
| DOI: |
10.1186/s11671-024-04041-5 |
| Popis: |
Abstract The growing use of thermoplastic composites (TPCs) like low-melting polyaryletherketone (LM-PAEK) matrices reinforced with unidirectional carbon fiber (CF) in aircraft structures presents a significant challenge in terms of lightning strikes and electromagnetic interference shielding during aircraft operations. This is due to the weak electrical conductivity of TPC structures, which results in widespread damage when struck by lightning. The repair and maintenance of these extended damaged sites can increase operational costs and loss of flights. Several lightning strike protection (LSP) systems have been developed and implemented to address these concerns. This study evaluated a highly conductive coating with a low filler rate for its effectiveness as an LSP solution for TPCs on exterior aircraft surfaces. The TPC panel without any coatings was first studied. Subsequently, the level of conductivity was increased by incorporating the nanoscale conductive fillers, silver-coated copper (Ag/Cu) nanoflakes, with a silver content of 20 wt.% (Ag20/Cu) and 30 wt.% (Ag30/Cu), correspondingly, into the coating at two loadings of 55 wt.% and 70 wt.% in an epoxy carrier for the surface coatings. The behavior of electrical and surface conductivity was thoroughly examined to understand the impact of Ag/Cu with a high aspect ratio and the effectiveness of the LSP solution. In addition, the spray-coated TPC panels underwent rigorous Zone 2A lightning strike testing using simulated lightning current, in agreement with the industry standard of Society of Automotive Engineers (SAE) Aerospace Recommended Practice (ARP) 5412B. Despite the higher resistance due to the lower conductive coating weight, the TPC panels with Ag30/Cu at loading of 70 wt.% achieved better results than those with Ag30/Cu at loading of 55 wt.%. This is evidenced by the minor structural delamination and CF breakage on the front surface, which proposes a new economic route for a sustainable post-processed LSP system in the aviation industry. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
Full text from SpringerLink