| Autor: |
N. Anderson, P. Pringle, R. Mead-Hunter, B. Mullins, A. Larcombe, S. Allard |
| Jazyk: |
angličtina |
| Rok vydání: |
2023 |
| Předmět: |
|
| Zdroj: |
Aerosol Research, Vol 1, Pp 17-27 (2023) |
| Druh dokumentu: |
article |
| ISSN: |
2940-3391 |
| DOI: |
10.5194/ar-1-17-2023 |
| Popis: |
Electronic cigarettes (e-cigarettes) lack regulatory status as therapeutic products in all jurisdictions worldwide. They are potentially unsafe consumer products, with significant evidence they pose a risk to human health. Therefore, developing rapid, economical test methods to assess the chemical composition of e-liquids in heated and unheated forms and the aerosols produced by e-cigarettes is crucial. Four different e-liquids were heated using two different methods: (1) “typical” vaping using an e-cigarette device, by cycling “on” for 3 s every minute for 2 h (e-liquid obtained from remainder in the tank and aerosol collected in an impinger), and (2) “accelerated” heating, using an e-cigarette coil submerged in e-liquid and heating in short 20 s bursts on then 20 s off for 2 min only (liquid traps aerosol produced). All e-liquids were then analysed to test for the presence and quantity of 13 chemicals by gas chromatography–mass spectrometry and compared to an unheated sample. E-liquids heated with the accelerated method showed a comparable trend to the typical heating method, i.e. increase or decrease in chemical compound quantity, for more than two-thirds of the detected compounds analysed over all e-liquids. Six chemicals were detected as aerosol from the impinger fluid with the typical heating method at negligible levels. We propose that this accelerated version of the typical vaping method could form the basis of a standardized screening tool to test heated e-liquids (and e-cigarette aerosols) for harmful or banned substances. This will ensure that only approved products reach the consumer and reduce potential e-cigarette harm. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
