Effect of 3D printed teeth and virtual simulation system on the pre-clinical access cavity preparation training of senior dental undergraduates

Autor: Mengting Duan, Silei Lv, Bing Fan, Wei Fan
Jazyk: angličtina
Rok vydání: 2024
Předmět:
Zdroj: BMC Medical Education, Vol 24, Iss 1, Pp 1-9 (2024)
Druh dokumentu: article
ISSN: 1472-6920
DOI: 10.1186/s12909-024-05869-2
Popis: Abstract Background The objective of the present study was to evaluate the effect of 3D printed teeth and virtual simulation system on the pre-clinical access cavity preparation training of senior dental undergraduates. Methods The 3D printed teeth were manufactured based on the micro-CT data of an extracted lower first molar. Ninety-eight senior dental undergraduate students were required to finish the access cavity preparation of lower first molar within 20 min on plastic and 3D printed teeth on the manikin system as well as on a virtual simulation machine respectively with randomly selected sequences. Expert dentists scored the operated teeth. The scores from the virtual simulation system were also recorded. All the scores were analyzed and compared. Following the procedure, two questionnaires were sent to students to further evaluate the feelings and optimal training sequence. Results No significant differences were found between plastic and 3D printed teeth scores, while virtual simulation achieved a valid/invalid area removal ratio of 96.86% ± 5.08% and 3.97% ± 1.85%, respectively. Most students found plastic teeth training the easiest and favored the three-training combination (36.36%). 71.42% of the students thought the virtual simulation training should be put at the first place of the three trainings. Over 80% of students agreed with incorporating 3D printed teeth and virtual simulation into their routine training courses. In addition, the general advantages and disadvantages of the virtual simulation system and 3D printed teeth training received almost equal recognition by students. Conclusions Virtual simulation system training + plastic teeth training + 3D printed teeth training might be the optimal training sequence. Virtual simulation system training could not completely replace the traditional training methods on the manikin system at the moment. With further modifications, 3D printed teeth could be expected to replace the plastic teeth for the pre-clinical access cavity preparation training.
Databáze: Directory of Open Access Journals
Externí odkaz: