Evaluation of the non-metallic compounds on secondary refining – Ruhrstahl Heraeus (RH) process
| Autor: | Paulo André Pereira, Demetrius Da Rós Ruy, Jorge Alberto Soares Tenório, Cássio Santos de Carvalho, José Roberto de Oliveira, Raphael Mariano de Souza, Estéfano Aparecido Vieira |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2024 |
| Předmět: | |
| Zdroj: | REM: International Engineering Journal, Vol 77, Iss 4 (2024) |
| Druh dokumentu: | article |
| ISSN: | 2448-167X 0370-4467 |
| DOI: | 10.1590/0370-44672023770009 |
| Popis: | Abstract The purpose of this study was to evaluate the cleanliness of Interstitial Free (IF) steels produced in a Ruhrstahl Heraeus (RH) vacuum degasser by determining the level of Al2O3 and Al-Ti-O inclusion types generated in three different process conditions: i) steel processed without thermal intervention; ii) steel processed with chemical heating and iii) steel processed with cooling by the scrap addition. The inclusion formation and remotion during these processes were analyzed. The influence of homogenization time was also studied. The content of inclusions was measured by a Scanning Electron Microscope (SEM) with an automated counting system denoted as Automated Steel Cleanliness Analysis Tool (ASCAT). This method can provide the size and composition of non-metallic compounds. The results have shown that the Ruhrstahl Heraeus (RH) process can improve the remotion efficiency of the inclusions, such as those larger than 2.5 mm, which is due to the molten steel circulating in RH vessel. For some inclusion types, higher concentrations were detected, but their size was smaller. For a heat where it was necessary to apply chemical heating using Al addition and O injection, there was detected a higher concentration of inclusions when compared with that cooled by scrap addition. In cooling heats, there is a strong generation of small and thin inclusions ( |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|