| Autor: |
P. K. Jayashree, Sathyashankara Sharma, Sourabh Kumar, Bhagyalaxmi, Mithesh Bangera, Ritesh Bhat |
| Jazyk: |
angličtina |
| Rok vydání: |
2023 |
| Předmět: |
|
| Zdroj: |
Journal of Composites Science, Vol 7, Iss 2, p 78 (2023) |
| Druh dokumentu: |
article |
| ISSN: |
2504-477X |
| DOI: |
10.3390/jcs7020078 |
| Popis: |
An aluminum 6061 (Al6061) metal matrix composite (MMC) reinforced with silicon carbide was prepared by stir casting. Specimens of the required dimensions were welded using the tungsten inert gas (TIG) method. ER5356 (Al-5%Mg) was chosen as the appropriate filler material for TIG welding. The input current parameter was varied (150, 170 and 200nA) while maintaining the other welding parameters at constant values. An assessment of the mechanical (tensile and impact strength) and microstructure properties of the TIG-welded Al6061 MMC with 6 wt. % silicon carbide particles was accomplished. An 8.27% improvement was observed in ultimate tensile strength (UTS) for the 150 A TIG-welded sample. UTS and elasticity decreased linearly with an increase in welding current but exhibited higher values than in non-welded specimens. The microstructural analysis of the welded MMCs showed a mixed mode of failure, with equiaxial dimples being dominant in lower-weld-current specimens. Compared to non-welded specimens, a 40% increase in impact strength was observed for the 150 A TIG-welded specimens, which decreased with an increase in the welding current value. SEM analysis revealed ductile striations and continuous river patterns, resulting in mixed failure. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
