The Effects on Screw Fasteners Spacing on Flexural Behavior and Strength Capacity of Cold-Formed Steel Built-Up Box Sections
| Autor: | Maria Yasinta Menge Making, Ali Awaludin, Bambang Supriyadi |
|---|---|
| Jazyk: | English<br />Indonesian |
| Rok vydání: | 2021 |
| Předmět: | |
| Zdroj: | Media Komunikasi Teknik Sipil, Vol 26, Iss 2, Pp 163-173 (2021) |
| Druh dokumentu: | article |
| ISSN: | 0854-1809 2549-6778 |
| DOI: | 10.14710/mkts.v26i2.31503 |
| Popis: | The capacity and behaviour of cold-formed steel built-up sections are affected by the arrangement of the connections. This study aims to determine the effect of the screw spacing to the bending capacity and behaviour of the cold-formed steel built-up box section which made from lipped-channel (1.0 mm thick, 81 mm web height, 8.5 mm lip height, upper and lower wing width 38 mm and 40 mm). A total of 19 beams with a length of 1200 mm each are subjected to pure bending moments by applying two point loads spaced 600 mm in the midspan. The screw spacing variations in the moment span are 100 mm, 150 mm, 200 mm, 250 mm, 300 mm, 328 mm, and 350 mm. The test results show the average of bending capacity of the beam test is increasing with the reduction in screw spacing while the screw configuration also affects the beam capacity. Analysis of the bending capacity using the effective width method and the direct strength method based on AISI S100-16 gives very conservative results. The failure mode of the built-up box sections were observed in the form of local buckling, distortion, and lateral-torsional buckling. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|