| Autor: |
T. Sathish, L. Natrayan, S. Prasad Jones Christydass, S. Sivananthan, R. Kamalakannan, V. Vijayan, Prabhu Paramasivam |
| Jazyk: |
angličtina |
| Rok vydání: |
2022 |
| Předmět: |
|
| Zdroj: |
Advances in Materials Science and Engineering, Vol 2022 (2022) |
| Druh dokumentu: |
article |
| ISSN: |
1687-8442 |
| DOI: |
10.1155/2022/9349847 |
| Popis: |
Aluminum is among the most preferred materials based on the desired properties. This investigation focused on to evaluate the wear rate of the AA6066 aluminium alloy composite by using pin-on-disc apparatus. The composites were created with three materials such as AA6066 alloy, high-speed steel, and copper which have a volume percentage variation of 92%, 5%, and 3%, respectively. These three parameters were considered for the experimental results of the wear rate such as load applied, sliding speed, and sliding distance. Experimental results of the composites were compared using an applied load of 20 N, a sliding velocity of 3.0 m/s and 1800 m of sliding distance with AAHSSCu reinforced composites offering a minimum wear rate. Similarly, using a 40 N applied load, the minimum wear rate is obtained. Further increasing the applied load to 60 N with 600 m of sliding distance provided a lower wear rate. The various graphical representations such as three-dimensional surface plots, contour plots, and bar charts were used for the experimental results. Wear rate consequences were expressed individually compared based on the considered parameters. Experimental results were having the reliability of nearly ninety-one percentage with only wear rate being focused. Finally, an optimized wear rate is obtained at the sliding distance of 1200 m with an applied load of 40 N and a spindle speed of 3 m/s. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|
