Experimental Study of Thermal Resistance Values of Natural Fiber Insulating Materials under Different Mean Temperatures
| Autor: | Duong Hung Anh Le, Zoltán Pásztory |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2023 |
| Předmět: | |
| Zdroj: | South-East European Forestry, Vol 14, Iss 1, Pp 93-99 (2023) |
| Druh dokumentu: | article |
| ISSN: | 1847-6481 1849-0891 |
| DOI: | 10.15177/seefor.23-03 |
| Popis: | The purpose of this paper is to experimentally study the thermal resistance (RSI value) of building insulation materials made mainly from natural fiber. Natural fibrous materials or renewable resources and their reinforcement composites are currently being used in building and construction as a potential solution to significantly reduce thermal load and energy consumption. The RSI value is used in describing the thermal efficiency of insulating material and in an analysis of heat transfer through the structural components of a building (such as walls, roofs, and windows) under steady-state conditions. In this study, the thermal resistance values of several samples made from coir fiber, rice straw fiber, energy reed fiber, and coconut wood were calculated from the thermal conductivity which was measured at mean temperature of 20°C, using the heat flow apparatus. The lowest RSI value was recorded in the phenol-formaldehyde polymer composites reinforced by rice straw fiber (0.115 m2·K·W-1) and coir fiber (0.128 m2·K·W-1) due to the relative thinness of the tested samples (8 and 12 mm). However, these samples can be used as an additional layer in multi-layered assemblies because of their low thermal conductivity value. The highest RSI value was reported on the binderless coir fiber panel (0.909 m2·K·W-1) at the thickness of 50 mm. Another investigation examined the relationship between RSI value and mean temperature to observe the influence of variations of ambient temperature on the heat resistivity of building insulation materials. Practical data showed the decreased linear proportion between thermal resistance and specific mean temperatures increased from 0 to 40°C. It is apparent that an increase in the interior and exterior temperature of a building significantly influences the thermal resistance of its insulation materials. Based on the experimental study, once the thermal conductivity coefficient of each sample was determined, the calculated RSI value was a valuable parameter to evaluate the thermal resistant effectiveness of a multi-layered installation, which allows us to investigate practically the effect of the thickness of additional layers from different insulating materials used in building envelopes. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|