Effect of interference on fretting wear of planetary frame axle hole
| Autor: | Zhipeng Lyu, Fuyuan Wang, Sizhu Zhou, Si Liu |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2020 |
| Předmět: | |
| Zdroj: | Advances in Mechanical Engineering, Vol 12 (2020) |
| Druh dokumentu: | article |
| ISSN: | 1687-8140 16878140 |
| DOI: | 10.1177/1687814020919225 |
| Popis: | In order to study fretting wear damage law of planetary frame axle hole, the distribution of normal stress and relative sliding velocity at axle hole was obtained by finite element software, and a method of extracting fretting wear characteristic parameter data was put forward and verified. According to the modified model of fretting wear depth calculation, the wear depth of each step at axle hole was calculated, and the influence of interference on wear depth was analyzed. The results show that the stress distribution obtained by this method corresponds to the values of each node in the Workbench stress nephogram at that time and has the same distribution rule, which shows that the method is correct. The stress concentration near the inner part of the axle hole of the planetary frame is obvious. Along the circumferential and axial direction of the shaft hole, the relative slip velocity of both ends is larger, and the relative slip velocity of the middle part is smaller. Average wear in both axial and circumferential directions increases with the increase in interference, while wear in the axial direction plays a dominant role in the whole meshing process. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|