| Autor: |
Jacek Górka, Mateusz Przybyła |
| Jazyk: |
angličtina |
| Rok vydání: |
2024 |
| Předmět: |
|
| Zdroj: |
Materials, Vol 17, Iss 14, p 3560 (2024) |
| Druh dokumentu: |
article |
| ISSN: |
1996-1944 |
| DOI: |
10.3390/ma17143560 |
| Popis: |
The aim of this study was to analyze the effect of the HFMI (high-frequency mechanical impact) treatment of each weld bead on the properties of a butt joint with a ceramic backing welded by robotic method 135 (MAG—metal active gas welding method) and to determine the effect of HMFI on the stress level. This analysis was based on a comparison of three butt joints made of a S690QL plate, in the as-welded condition, with the HFMI of each bead and with the heat treatment carried out with PWHT stress relief annealing. The high-frequency (90 Hz) peening of each weld bead was linked with a stress reduction in the weld via the implementation of compressive stresses into the joint. The HFMI pneumatic hammer was used for this. The correctness of treatment was achieved when 100% of the surface of each bead including the face was treated. As part of the post-welding tests, basic tests were carried out based on the standards for the qualification of welding technology, and as a supplementary test, a stress state analysis using the Barkhausen effect was carried out. The tests carried out showed that the use of high-frequency peening after each pass did not affect the negative results of all the required tests when qualifying the welding technology of S690QL sheet metal compared to the test plates in the as-welded condition and after heat treatment—stress relief annealing. Inter-pass peening of the welded face and HAZ (heat-affected zone) resulted in a reduction in post-weld residual stresses at a distance of 12 mm from the joint axis compared to the stress measurement result for the sample in the as-welded condition. This allowed for a positive assessment of peening in the context of reducing the notch, which is the concentration of tensile stresses in the area of the fusion line and HAZ. The tests carried out showed that the peening process does not reduce the strength properties of welded joints, and the results obtained allow the technology to be qualified based on applicable standards. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|
