| Popis: |
The underwater 10CrNi3MoV high-strength low-alloy steel thin-walled part with forming quality up to in-air laser deposition quality was successfully manufactured for the first time. The influencing mechanisms of complicated thermal history and water environment on microstructure evolution and mechanical properties of thin-walled part were researched. Due to austenitization and interlocking effect, the microstructure in the bottom, middle and top (below the 56th layer) areas of underwater sample and the middle area of in-air sample were composed of fine grain ferrite and granular bainite. With the increase of building height, the heat accumulation effect of underwater sample enhanced, resulting in small grain size (GS), high dislocation density, strong solution strengthening effect and low maximum texture strength at the bottom area, while the high proportion of high-angle grain boundaries (HAGBs) at the top area. These resulted in the greatest tensile strength (714 MPa) and microhardness (232 HV) at the bottom area and the highest elongation (11%) at the top area. Due to the cooling effect of water environment, the proportion of HAGBs reduced and there were oxides in fracture. As a result, the horizontal elongation of underwater sample was about 90.9% of in-air sample. Additionally, the GS reduced, and the dislocation density and solution strengthening effect increased, so the microhardness of underwater sample was slightly higher than that of in-air sample. However, due to some microscopic defects, the horizontal and vertical tensile strength of underwater sample were about 97.6% and 90.7% of in-air sample. |
