| Autor: |
Liang, Yu, Zhao, Lei, Guo, Yuxiang, Qin, Jiajun, Yang, Yunfang, Cheng, Boyu, Liu, Shubin, An, Qi |
| Rok vydání: |
2019 |
| Předmět: |
|
| Zdroj: |
Journal of Instrumentation, Vol. 13, Jan. 2018, pp. P01023-1 - P01023-15 |
| Druh dokumentu: |
Working Paper |
| Popis: |
Time and charge measurements over a large dynamic range from 1 Photo Electron (P.E.) to 4000 P.E. are required for the Water Cherenkov Detector Array (WCDA), which is one of the key components in the Large High Altitude Air Shower Observatory (LHAASO). To simplify the circuit structure of the readout electronics, a front end ASIC was designed. Based on the charge-to-time conversion method, the output pulse width of the ASIC corresponds to the input signal charge information while time information of the input signal is picked off through a discriminator, and thus the time and charge information can be digitized simultaneously using this ASIC and a following Time-to-Digital Converter (TDC). To address the challenge of mismatch among the channels observed in the previous prototype version, this work presents approaches for analyzing the problem and optimizing the circuits. A new version of the ASIC was designed and fabricated in the GLOBALFOUNDRIES 0.35 um CMOS technology, which integrates 6 channels (corresponding to the readout of the 3 PMTs) in each chip. The test results indicate that the mismatch between the channels is significantly reduced to less than 20% using the proposed approach. The time measurement resolution better than 300 ps is achieved, and the charge measurement resolution is better than 10% at 1 P.E., and 1% at 4000 P.E., which meets the application requirements. |
| Databáze: |
arXiv |
| Externí odkaz: |
|
