Desulphurization of the high-alloy and middle-alloy steels under the conditions of an EAF by means of synthetic slag based on CaO-Al2O3: Razžvepljanje močno in srednje legiranih jekel v elektroobločni peči s sintetično žlindro na osnovi CaO-Al2O3

Autor: Čamek, Libor, Gryc, Karel, Huczala, Tomáš, Michalek, Karel, Tkadlečková, Markéta, Troszok, Vladimír
Jazyk: angličtina
Rok vydání: 2012
Zdroj: Materiali in tehnologije
Popis: The article deals with the results of the experimental heats performed in the electric steel plant of TŘINECKÉ ŽELEZÁRNY, a. s. (TŽ, a. s.). The aim was to verify the possibility of deep desulphurization of steel in the basic 10-t electric arc furnace. Experimental procedures making use of the industrially produced synthetic slag were applied in the production of the high-alloy chrome steels and the middle-alloy tool steels, where the desulphurization, interms of thermodynamics, is a more demanding process than the chrome-nickel steel desulphurization. With the use of the technological processes it is possible to achieve low contents of sulphur in steel, below mass fraction 0.003 %. Achieving these contents depends on a suitable slag basicity, and, inparticular, on the ratio of CaO/Al2O3. Based on the analysis of the results, a critical factor significantly affecting the final content of the sulphur and thus the efficiency of the desulphurization of steel, the content of FeO in the reduction slag, is carefully considered. A higher MgO content in slag (up to w = 25 %) had no significant influence on the results of the steel desulphurization. Članek predstavlja rezultate eksperimentalnih talin, izdelanih v TŘINECKÉ ŽELEZÁRNY, a. s. (TŽ, a. s.). Namen raziskav je bil preveriti možnost močnega razžvepljanja jekla v bazični 10-tonski elektropeči. Izvršena je bila raziskava z uporabo industrijsko proizvedene sintetične žlindre pri proizvodnji močno legiranega kromovega jekla in srednje legiranega orodnega jekla, pri katerih je termodinamika razžvepljanja bolj zapletena kot pri razžvepljanju krom-nikljevih jekel. S primernimi tehnološkimi ukrepi je mogoče doseči v jeklu majhno vsebnost žvepla, nižjo od masnega deleža 0,003 %. Doseganje teh vsebnosti je odvisno od primerne bazičnosti žlindre in posebno še od razmerja CaO/Al2O3. Na osnovi analize rezultatov je bil določen kritični faktor, vsebnost FeO v redukcijski žlindri, ki močno vpliva na končno vsebnost žvepla in s tem na učinkovitost razžvepljanja. Večja vsebnost MgO (do masnega deleža 25 %) v žlindri nima večjega vpliva na razžvepljanje jekla.
Databáze: OpenAIRE