| Popis: |
Raziskovanje diplomskega dela se nanaša na razvoj slovenske livarne, ki se je specializirala za litje orodij za steklarsko industrijo. V začetku leta 2016 je podjetje zagnalo novo formarsko linijo, ki je prinesla povečanje kapacitet, po drugi strani pa kar nekaj sprememb, na katere podjetje ni bilo pripravljeno. To so pokazali prvi rezultati v primerjavi s starejšo formarsko linijo. Takrat je postalo jasno, da bodo razlike v linijah (geometrijske, mehanske) še kako vplivale na potek procesa in njegovo pripravo. Zato smo se odločili za optimizacijo modelnih plošč, saj je to področje, ki lahko bistveno izboljša izkoriščenost linije. Exploring the thesis describes the development of Slovenian foundry, which is specialized in casting tools for the glass industry. In early 2016 the company launched the new molding line, which has brought an increase in capacity, on the other hand, quite a few changes over which the company has not been prepared. This was shown the first results compared with the old molding line. Then it became clear, that there will be differences in lines (geometric, mechanical), and will influence the course of the process and its preparation. Therefore, I have decided to optimize the model plates, as this is an area that can significantly improve the utilization of the line. |
