Circumferential steady-state creep test and analysis of Zircaloy-4 fuel cladding
| Autor: | Chang-Hwan Shin, Byoung Jae Kim, Jae Yong Kim, Gyeong-Ha Choi |
|---|---|
| Rok vydání: | 2021 |
| Předmět: |
Cladding (metalworking)
Materials science 020209 energy Tube burst test Zircaloy-4 fuel cladding 02 engineering and technology Deformation (meteorology) Isothermal process Physics::Geophysics 030218 nuclear medicine & medical imaging Physics::Fluid Dynamics 03 medical and health sciences 0302 clinical medicine Condensed Matter::Superconductivity 0202 electrical engineering electronic engineering information engineering Anisotropy Circumferential creep Steady state TK9001-9401 Isotropy Zirconium alloy Mechanics Steady-state creep Nuclear Energy and Engineering Creep DIMAT(Deformation in-situ measurement apparatus by image-analysis technique) Nuclear engineering. Atomic power |
| Zdroj: | Nuclear Engineering and Technology, Vol 53, Iss 7, Pp 2312-2322 (2021) |
| ISSN: | 1738-5733 |
| DOI: | 10.1016/j.net.2021.01.010 |
| Popis: | In recent studies, the creep rate of Zircaloy-4, one of the basic property parameters of the nuclear fuel code, has been commonly used with the axial creep model proposed by Rosinger et al. However, in order to calculate the circumferential deformation of the fuel cladding, there is a limitation that a difference occurs depending on the anisotropic coefficients used in deriving the circumferential creep equation by using the axial creep equation. Therefore, in this study, the existing axial creep law and the derived circumferential creep results were analyzed through a circumferential creep test by the internal pressurization method in the isothermal conditions. The circumferential creep deformation was measured through the optical image analysis method, and the results of the experiment were investigated through constructed IDECA (In-situ DEformation Calculation Algorithm based on creep) code. First, preliminary tests were performed in the isotropic β–phase. Subsequently in the anisotropic α-phase, the correlations obtained from a series of circumferential creep tests were compared with the axial creep equation, and optimized anisotropic coefficients were proposed based on the performed circumferential creep results. Finally, the IDECA prediction results using optimized anisotropic coefficients based on creep tests were validated through tube burst tests in transient conditions. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|