Investigation on component wall angle in single stage incremental forming of austenitic stainless steel AISI 304 sheet
| Autor: | Mohamed Farhan, N. Ethiraj, T. Bernadette, D Suresh Kumar, T. Sivabalan |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2020 |
| Předmět: |
Work (thermodynamics)
Materials science Component (thermodynamics) Single stage Mechanical Engineering tool rotational speed Rotational speed engineering.material Sheet material austenitic stainless steel single stage incremental forming incremental depth Mechanics of Materials wall angle lcsh:TA1-2040 engineering Austenitic stainless steel Composite material lcsh:Engineering (General). Civil engineering (General) lcsh:Mechanics of engineering. Applied mechanics lcsh:TA349-359 |
| Zdroj: | FME Transactions, Vol 48, Iss 2, Pp 391-396 (2020) |
| ISSN: | 1451-2092 |
| Popis: | The aim of this research work is to study the effect of process parameters in achieving the maximum possible wall angle of the component in single stage incremental forming. Austenitic stainless steel AISI 304 is used as a sheet material. The constant tool rotational speed of 250 rpm, tool feed of 1000 mm/min and incremental depth of 0.5 mm were used as process parameters and the wall angle was varied from 60°.Grid marking technique is used for strain measurements. From the results, it is observed that the maximum height of 45 mm was formed successfully at wall angles 60°, 61°, 63° and 64° without any defects within the experimented process parameters. Further increase in either the wall angle or the process parameters produced fractured component at a height of around 22 mm itself. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|