Continuous in situ measurements of anchor ice formation, growth, and release
| Autor: | Tadros R. Ghobrial, Mark R. Loewen |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2021 |
| Předmět: |
lcsh:GE1-350
Materials science Buoyancy 010504 meteorology & atmospheric sciences Ice crystals lcsh:QE1-996.5 0211 other engineering and technologies Anchor ice Mineralogy 02 engineering and technology engineering.material 01 natural sciences Freezing point lcsh:Geology Water column 13. Climate action Phase (matter) engineering Deposition (phase transition) lcsh:Environmental sciences 021101 geological & geomatics engineering 0105 earth and related environmental sciences Earth-Surface Processes Water Science and Technology Frazil ice |
| Zdroj: | The Cryosphere, Vol 15, Pp 49-67 (2021) |
| ISSN: | 1994-0424 |
| Popis: | In northern rivers, turbulent water becomes supercooled (i.e. cooled to slightly below the freezing point) when exposed to freezing air temperatures. In supercooled turbulent water, frazil (small ice disks) crystals are generated in the water column, and anchor ice starts to form on the bed. Two anchor ice formation mechanisms have been reported in the literature: either by the accumulation of suspended frazil particles, which are adhesive (sticky) in nature, on the riverbed or by in situ growth of ice crystals on the bed material. Once anchor ice has formed on the bed, the accumulation typically continues to grow (due to either further frazil accumulation and/or crystal growth) until release occurs due to mechanical (shear force by the flow or buoyancy of the accumulation) or thermal (warming of the water column which weakens the ice-substrate bond) forcing or a combination of the two. There have been a number of detailed laboratory studies of anchor ice reported in the literature, but very few field measurements of anchor ice processes have been reported. These measurements have relied on either sampling anchor ice accumulations from the riverbed or qualitatively describing the observed formation and release. In this study, a custom-built imaging system (camera and lighting) was developed to capture high-resolution digital images of anchor ice formation and release on the riverbed. A total of six anchor ice events were successfully captured in the time-lapse images, and for the first time, the different initiation, growth, and release mechanisms were measured in the field. Four stages of the anchor ice cycle were identified: Stage 1: initiation by in situ crystal growth; Stage 2: transitional phase; Stage 3: linear growth; and Stage 4: release phase. Anchor ice initiation due to in situ growth was observed in three events, and in the remainder, the accumulation appeared to be initiated by frazil deposition. The Stage 1 growth rates ranged from 1.3 to 2.0 cm/h, and the Stage 2 and 3 growth rates varied from 0.3 to 0.9 cm/h. Anchor ice was observed releasing from the bed in three modes: lifting of the entire accumulation, shearing of layers of the accumulation, and rapid release of the entire accumulation. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|