Distrontium Cerate as a Radiopaque Component of Hydraulic Endodontic Cement
| Autor: | Kunlanun Dumrongvute, Sherif Adel, Takahiro Wada, Nobuyuki Kawashima, Chinalai Piyachon, Hiroshi Watanabe, Tohru Kurabayashi, Takashi Okiji, Motohiro Uo |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2022 |
| Předmět: |
Technology
Microscopy QC120-168.85 QH201-278.5 distrontium cerate (2SrO·CeO2) flowability compressive strength Engineering (General). Civil engineering (General) Article TK1-9971 hydraulic endodontic cement Descriptive and experimental mechanics General Materials Science Electrical engineering. Electronics. Nuclear engineering TA1-2040 radiopacity |
| Zdroj: | Materials, Vol 15, Iss 284, p 284 (2022) Materials Materials; Volume 15; Issue 1; Pages: 284 |
| ISSN: | 1996-1944 |
| Popis: | This study aimed to synthesize distrontium cerate (2SrO·CeO2: S2Ce) and evaluate its properties as an alternative component of the endodontic cement. S2Ce cement was prepared through calcination of strontium hydroxide and cerium carbonate. Subsequently, the crystal phase was confirmed using X-ray diffraction. S2Ce cement exhibited a rapid setting time (121 min) and achieved a high compressive strength (72.1 MPa) at 1 d after mixing, comparable to the compressive strength of a commercial mineral trioxide aggregate (MTA) cement (ProRoot MTA) after 28 d post mixing. However, the compressive strength decreased after 28 d of storage when the W/P ratio was 0.30–0.40 (p < 0.05). Ion dissolution test of the S2Ce cement showed that strontium ions were released after immersion in water (5.27 mg/mL after 1 d), whereas cerium dissolution was not detected. S2Ce exhibited approximately three times higher radiopacity (9.0 mm aluminum thickness equivalent) compared to the commercial MTA (p < 0.05). These findings suggest that S2Ce is a possible component for hydraulic endodontic cement that demonstrates a rapid setting and high radiopacity. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|