Intermediate strain rate material characterization with digital image correlation
| Autor: | David Backman, Richard Desnoyers, Meysam Rahmat |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2019 |
| Předmět: |
Digital image correlation
General Immunology and Microbiology Computer science General Chemical Engineering General Neuroscience Reproducibility of Results Strain rate General Biochemistry Genetics and Molecular Biology Dynamic load testing Single test Limited access Materials Testing Ultimate tensile strength Image Processing Computer-Assisted Stress Mechanical Strain gauge Simulation Quasistatic process |
| DOI: | 10.3791/59168 |
| Popis: | The mechanical response of a material under dynamic load is typically different than its behavior under static conditions; therefore, the common quasistatic equipment and procedures used for material characterization are not applicable for materials under dynamic loads. The dynamic response of a material depends on its deformation rate and is broadly categorized into high (i.e., greater than 200/s), intermediate (i.e., 10-200/s) and low strain rate regimes (i.e., below 10/s). Each of these regimes calls for specific facilities and testing protocols to ensure the reliability of the acquired data. Due to the limited access to high-speed servo-hydraulic facilities and validated testing protocols, there is a noticeable gap in the results at the intermediate strain rate. The current manuscript presents a validated protocol for the characterization of different materials at these intermediate strain rates. Strain gauge instrumentation and digital image correlation protocols are also included as complimentary modules to extract the utmost level of detailed data from every single test. Examples of raw data, obtained from a variety of materials and test setups (e.g., tensile and shear) is presented and the analysis procedure used to process the output data is described. Finally, the challenges of dynamic characterization using the current protocol, along with the limitations of the facility and methods of overcoming potential problems are discussed. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|