Commentary: Chloride Regulation: A Dynamic Equilibrium Crucial for Synaptic Inhibition
Autor: | Tushar Devanand Yelhekar, Michael Druzin, Staffan Johansson |
---|---|
Rok vydání: | 2016 |
Předmět: |
0301 basic medicine
Fysiologi chloride Physiology K+ Cl- cotransporter 2 equilibrium potential Cl concentration Inhibitory postsynaptic potential Chloride Equilibrium potential K+ Cl− cotransporter 2 lcsh:RC321-571 03 medical and health sciences Cellular and Molecular Neuroscience 0302 clinical medicine medicine Cl- Concentration lcsh:Neurosciences. Biological psychiatry. Neuropsychiatry Dynamic equilibrium Membrane potential Chemistry Neurosciences Cl− channel Conductance Depolarization synaptic inhibition 030104 developmental biology Cl− concentration Excitatory postsynaptic potential Biophysics Cl- channel membrane potential Cotransporter Algorithm Neurovetenskaper 030217 neurology & neurosurgery Neuroscience medicine.drug conductance |
Zdroj: | Frontiers in Cellular Neuroscience, Vol 10 (2016) |
ISSN: | 1662-5102 |
Popis: | The recent review by Doyon et al. (2016) is for the main part an excellent description of many important aspects of neuronal chloride regulation and will be of good use to many scientists interested in synaptic function. Nevertheless, some information given on the role of the K+ Cl− cotransporter 2 (KCC2) is likely to be misleading. While proposing an explanation for the controversial findings by Glykys et al. (2014) that blockers of cation-chloride cotransporters did not affect the basal intracellular Cl− concentration ([Cl−]i), contrary to expectations from previous transporter manipulations (see e.g., references in Ben-Ari, 2014; Kaila et al., 2014), Doyon et al. (2016) suggest that this may be due to the small degree of inhibitory synaptic activity in the preparation used, with extremely low Cl− load. In their explanation, they give an equation for the equilibrium relation between Cl− flux through an inhibitory (Cl−) conductance (ginh) and the Cl− transported by KCC2. On basis of this equation, the conclusion is that the Cl− equilibrium potential “ECl is sensitive to changes in KCC2 activity (gKCC2) only when Cl− load (ginh) is large.” This conclusion, however, cannot be justified on basis of the relation between Cl− flux through channels and Cl− transported by KCC2. (The equation given by Doyon et al. is not correctly formulated, although the reason for their claim may not depend on this mistake). For an explanation of our point of view, consider a hypothetical cell with Cl− transport across the outer membrane only via Cl− selective channels and KCC2. At equilibrium, the amount (mol/s) of Cl− transported by the channels must be equal, but opposite, to that transported by KCC2. We thus formulate the relation: ICl/F = gKCC2UKCC2 (1) where ICl is Cl− current, F is the Faraday constant and UKCC2 is the driving force for transport by KCC2. gKCC2 is a proportionality factor that may be thought of as an “apparent conductance,” and should reflect the number of transporters in the membrane as well as the transport rate of the individual transporter molecules at fixed K+ and Cl− concentrations, similarly as ICl depends on the Cl− conductance (gCl) which reflects the number of Cl− channels as well as the conductance of individual channels. (gKCC2 is, however, not a conductance in the usual electrical sense). Equation (1) may be reformulated, in several steps, for clarity: gCl (Vm−ECl)/F=gKCC2 (RT ln ([Cl−]i/[Cl−]o)+RT ln ([K+]i/[K+]o)) (2) gCl (Vm−ECl)/F = gKCC2 F (ECl−EK) (3) ECl=(gKCC2 F2 EK+gClVm)/ (gKCC2 F2+gCl) (4) where Vm is membrane potential, R the gas constant, T temperature (in K), EK the K+ equilibrium potential and Cl− and K+ concentrations are given within brackets with subscripts i and o for inside and outside, respectively. We may use Equation (4) to illustrate the relation between ECl and gKCC2 at various levels of gCl. (Assume that K+ concentrations and membrane potential are fixed, as controlled by other factors, such as the cellular Na+-K+-ATPase, not discussed here). As can be seen in Figure Figure1A,1A, contrary to the claim by Doyon et al. (2016), ECl is only weakly dependent on KCC2 transport capacity at high Cl− conductance, while it depends strongly on KCC2 when Cl− conductance is low. At the extremes, when gKCC2 = 0, then ECl = Vm and when gCl = 0, then ECl = EK. Figure 1 Cl− equilibrium potential — dependence on KCC2 transporter capacity at various Cl− conductance and various membrane potentials. (A) ECl vs. gKCC2 with EK fixed at −100 mV and Vm at −60 mV. gCl as indicated. Note ... The relation between ECl (and thus [Cl−]i) and transporter capacity has some bearing for the interpretation of the controversial findings by Glykys et al. (2014). Contrary to the suggestion by Doyon et al. (2016), Figure Figure1A1A shows that transporter block is expected to affect basal [Cl−]i especially under conditions when gCl is low. Thus, other explanations than a low gCl must be sought for the controversial findings of Glykys et al. (2014). An increased gCl, perhaps due to increased non-specific leak, could in theory contribute to the limited effect of KCC2 blocker on [Cl−]i. On the other hand, the lack of excitatory synaptic input may contribute to a reduced sensitivity to transport block. In equation (4) above, a steady excitatory input may be represented simply by a more positive Vm, if we assume that EK is still maintained (by the cellular Na+-K+-ATPase). Figure Figure1B1B shows that although ECl is more positive, the dependence of ECl on gKCC2 is clearly stronger at more positive Vm. As described, an increased gCl (Figure (Figure1A)1A) or a more positive Vm (Figure (Figure1B)1B) will change ECl in positive direction. This may be exploited experimentally e.g., by combining GABA or glycine application with depolarization to achieve a dramatic change in ECl and rise in [Cl−]i (Karlsson et al., 2011). With such manipulations, it is obvious that the neuronal transporter capacity cannot prevent the changes in ECl and in steady-state [Cl−]i. Doyon et al. (2016) also note the neglected problem of apparent (illusory) conductance decrease based on recordings at different holding potentials when [Cl−]i is changing, a problem which has recently been described in more detail by Yelhekar et al. (2016). It may be noted that experimentally, the effects of a changing [Cl−]i on apparent conductance may be separated from true changes in conductance by using rapid voltage-ramp techniques (Karlsson et al., 2011; Yelhekar et al., 2016). |
Databáze: | OpenAIRE |
Externí odkaz: |