Multielement Analysis of Polyethylene Using Solid Sampling Electrothermal Vaporization ICP Mass Spectrometry

Autor: Luc Moens, Frank Vanhaecke, Marieke Verstraete, Martín Resano, Richard Dams
Rok vydání: 2000
Předmět:
Zdroj: Analytical Chemistry. 72:4310-4316
ISSN: 1520-6882
0003-2700
DOI: 10.1021/ac0002700
Popis: Next to laser ablation (LA) also electrothermal vaporization (ETV) from a graphite furnace as a means of sample introduction opens possibilities for direct analysis of solid samples using inductively coupled plasma mass spectrometry (ICPMS). In this paper, it is demonstrated that solid sampling ETV-ICPMS is very well suited for the determination of metal traces in polyethylene. A limited multielement capability is often cited as an important drawback of ETV-ICPMS. However, by studying the effect of monitoring an increasing number of mass-to-charge ratios on the signal profile (integrated signal intensity and repeatability) of selected analyte elements, the multielement capability of (solid sampling) ETV-ICPMS was systematically evaluated, and the results obtained suggest that, with a quadrupole-based ICPMS instrument, at least 11 elements can be determined "simultaneously" (from the same vaporization step), in essence without compromising the sensitivity or the precision of the results obtained. In this work, the "simultaneous" determination of Al, Ba, Cd, Cu, Mn, Pb, and Ti in a polyethylene candidate reference material has been accomplished, despite the large variation in analyte concentration (from 5 ng/g for Mn to 500 microg/g for Ti) and in furnace behavior (volatility) they exhibit. To avoid premature losses of Cd during thermal pretreatment of the samples, Pd was used as a chemical modifier. Two different calibration methods--external calibration using an aqueous standard solution and single standard addition--were studied and the results obtained were compared with those obtained using neutron activation analysis (NAA) and/or with the corresponding (candidate) certified values (if available). Single standard addition was shown to be preferable (average deviation between ICPMS result and reference value3%), although--except for Ba--acceptable results could also be obtained with external calibration.
Databáze: OpenAIRE
Externí odkaz: