Degree of conversion of light‐polymerized composite resin in implant prosthesis screw access opening

Autor: Se‐Hyun Park, Yoon‐Hyuk Huh, Chan‐Jin Park, Lee‐Ra Cho, Kyung‐Ho Ko
Rok vydání: 2023
Předmět:
Zdroj: Journal of Prosthodontics.
ISSN: 1532-849X
1059-941X
Popis: The mechanical and physical properties of implant screw access opening deteriorate if composite resin is not polymerized properly. Therefore, this study aimed to analyze the effect of using composite resin in implant access opening on the degree of conversion (DC).Two prosthetic materials (Co-Cr and zirconia), two types of composite resin (low and high viscosity), two light-cured resin depths (2 and 3 mm), and two polymerization methods (max-mode 10 s and mid-mode 20 s: 16 and 22 J/cm2, respectively) were considered (n = 192). The DC of the polymerized composite resin was measured through Fourier-transform infrared (FTIR) spectroscopy. The top and bottom surfaces of the polymerized composite resin body were observed through scanning electron microscopy. Multiple linear regression analysis and analysis of variance (ANOVA) were used to identify significant differences in DC (α = .05).The DC was lower when the low-viscosity composite resin (β = -0.431), light-polymerized resin depth of 2 mm (β = -0.430), zirconia prosthesis (β = -0.191), and mid-mode polymerization method (β = -0.164) were used. The resin type, depth of resin to be light-cured, prosthesis material, and polymerization method had an effect on the DC.Low-viscosity composite resin should be polymerized at a low irradiance and long polymerization time (such that the light-cured resin depth does not exceed 2 mm) to ensure proper composite resin polymerization in implant screw access opening. This article is protected by copyright. All rights reserved.
Databáze: OpenAIRE
Externí odkaz: