Three-dimensional finite element modeling of effect on the cutting forces of rake angle and approach angle in milling
| Autor: | Süleyman Neşeli, Suleyman Yaldiz, Hüseyin Sari, Kadir Gök, Erol Türkeş, Arif Gök |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2017 |
| Předmět: |
0209 industrial biotechnology
Engineering approach angle business.industry Mechanical Engineering finite element method Mechanical engineering 02 engineering and technology engineering.material Industrial and Manufacturing Engineering Finite element method Rake angle Metal cutting 020901 industrial engineering & automation rake angle Cutting force Tool steel business milling operations Simulation |
| Popis: | In this study, milling operations were carried out using AISI 1040 specimens steel in dry cutting conditions. The cutting tools used in the experiment include P20 tool steel and they also have three different approach angles (45 degrees, 60 degrees, 75 degrees) and rake angles (0 degrees, -6 degrees, -12 degrees). In milling experiments, cutting parameters with a depth of cut of 1.5mm, cutting speed of 193m/min, and feed rate of 313mm/min were selected. A comparison was presented between the force values which were obtained by measured value and predicted with numerical simulations, and then a good agreement was found between measured and predicted force values. As result of, it was observed that the rake and approach angles were effective in milling operations. Selcuk University Scientific Research Project DepartmentSelcuk University [06101047] The author(s) disclosed receipt of the following financial support for the research, authorship, and/or publication of this article: The experimental part of this study was supported by the Selcuk University Scientific Research Project Department under the project number of 06101047. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|